• Available for individual watches are much preferred
• 1200tpd being the highest preferred
• At least a Low-High selection

2) Selectable Winding Direction

• Alternating only would be fine; but all 3 directions is the best
• If the unit has a CW & CCW only selection, ensure you reverse the direction of wind daily to evenly exercise your timepiece

3) Wide Watch Slots

• Slots on the winding cup should be able to accomodate up to 47mm watch dials (including crown); 55mm being the largest dial diameter.
• Wide buckles should also be able to fit.

4) Individual Winding Heads

• Individual timepieces would have individual settings
• Having two watches causes unneccessary axial torque to a motor resulting in premature failures
• Single winding heads extends motor life in some ways

5) Motors

• Silent (low noise) - noise usually measured with watch winder lid closed
• Reliable (Durable)
• Easily replaceable when it breaks down

6) Power Source

• Both AC Mains and DC, Battery for table-top units - up to 3 or 4 winding heads
• AC Mains only for cabinet types; back-up battery preferred

7) Delay Start

• If the unit has a Delay Start feature; it'll be a bonus. Otherwise, just do one of the two...

- Place your watch in the winder but switch it ON the next day, or

- Set to a lower TPD when you place your watch in the winder. Reset the TPD to the normal one next day onwards if you're not wearing it.

Join a forum or horology club where you can get free advice from its members there.

Labels: watch winder features